Jetting MJet V0
JETTING MACHINE FOR CABLES 0,5-6MM AND DUCTS 3-16MM
Extremely compact jetting machine with electrical operation for cable dimensions between 0.5 - 6 mm and microduct dimensions between 3 - 16mm. No loose small parts, no screws and no tools needed to set up the machine. It takes less than 1 minute to change microduct or cable dimension. MJET V0 can be operated from the carry case which means the set up time is just a few minutes.
- Electric traction drive, supplied from the attached battery
- Permits jetting in larger tubes with smaller compressor unit, the motor doesn’t consume any air flow
- Electronic cable protection, if a stop or slip is detected the drive stops within 250 ms.
- Reduced stress on the cable due to adjustable traction force
- OLED display shows speed, current progress and cable pushing force.
- Maximum speed 250 m/s, 60 N pushing force.
- Made in Sweden
- 18 Volt standard Metabo Multivolt battery
- Max press. 16 Bar
- 0,5-6 mm cable diameter*
- 3-16 mm duct diameter
- Weight ~ 2 kgs
- MJET V0
- 18V Metabo Battery
- Battery charger
- Duct clamp for 5mm
- Cable guide 0-5mm
- Cable seal 10pcs of 1.8 and 2.2mm
- Carry case