Use coupon SALE20 to get the -20% discount!
- Fusion splicing made easy and affordable with the EasySplicer.
- For both Singlemode and Multimode fibres.
- Splicing time of less then 7 seconds.
- Loss estimation.
- Pull test of performed splices.
- Built in oven.
- Easy to use and to carry along.
- Perfect for the FTTH installer.
- Up to 5000 splices with one set of electrodes
- Oven (Built in)
- 2 pairs of fiber holders, 250um and 900um. * Cleaver
- Rechargeable battery pack (Built in)
- Carrying case
The EasySplicer is manufactured in Sweden and is designed for daily use. It is compact and extremely rugged, very easy to use and is designed and focused on ease of use for the installer.
The EasySplicer has only 3 buttons to navigate, with the main button performing the splicing. It is very precise; typical splicing losses are 0.03db (single mode).
The EasySplicer will also perform a pull test prior to giving the estimated splice loss. It will also advise the operator prior to splicing if there is a problem with the fiber and will identify the problem (eg “Bad fiber”, “Dirty fiber”).
The battery pack is small but powerful. It can perform up to 40 splices before requiring recharging. Extra bettery packs are also available to extend splicing time. These are easily exchanged in the field.
The EasySplicer does constant calibration for environmental changes (moisture) and the calibration tests can also be preferred manually. Calibration when performed is extremely quick taking typically only a few seconds. This ensures the splice will be as good as possible.
The EasySplicer uses the “V” groove method of splicing (same procedures ribbon splicers use), which has allowed the size of the unit to be kept very small. It has also allowed the splicer to be very cost effective.
The SBFS1 is one of the most inexpensive handheld splicers on the market yet has a performance equal to or better than units 4 or 5 times more expensive.
The EasySplicer is ideal for FTTH and FTTS applications and its operating environment of 0-40 degrees Celsius makes it ideal for indoor or outdoor applications.
The EasySplicer is truly innovative and ideal for the construction of fiber networks. It is fast, easy to use, accurate, and dependable making it the ideal tool for service providers as well as installers and contractors.
The EasySplicer has a splicing time of less than 7 seconds and comes with a 1 year warranty.
Splicing method V-groove (cladding alignment).
Fiber Types SMF, MMF 50/125μm and 62.5/125μm fiber, 250μm primary and 900μm secondary coated fiber.
Fiber Handling Fiber holders, 2 pairs (250 and 900).
Splice Programs 3 pre-defined. SMF, MMF, OM1.
Typical Splice Loss 0.03dB SMF, 0.01dB MMF.
Typical Cycle Time 7s + 35s (splice + oven cycle).
Sleeve Dimensions Max 64mm length, 2-5mm diameter supported by oven.
Communication USB, mini usb plug.
Memory Internal 1MB, External SD-Card.
Monitor LCD, color, 2.8 , 320×240 pixels.
Magnification Camera 140x.
Operating Environment 0-40°C, max 95% RH, non-condensing.
Power Sources External power supply, 6V, 1.5A, 100-240VAC 50-60Hz, Built in Li-Ion battery pack.
Splicing Capacity 60 splice + oven cycles.
Additional Features Loss estimation, Fiber fault detection, SD-card (optional) for logging etc.